Table of Contents
Advertisement
2.
Remove the front cover by loosening the
split pin. (Complete instructions for the
service position can be found on the
inside of the front cover).
3.
Loosen the two anti-scalp rollers, located
under the front cover.
4.
Fit the two anti-scalp rollers on each side
of the cutting unit's rear section.
!
WARNING!
Wear protective glasses when
dismantling the cutting unit. The
springs that tension the belt can fly
off and cause personal injury.
5.
Loosen the spring on the drive belt's belt
idler.
90
English-
REPAIR INSTRUCTIONS
Dismantling the front cover
Support wheels
Placement of the anti-scalp rollers
Spring on belt idler
6017-219
6017-220
6017-221
8009-598
Advertisement
Table of Contents
