10. Connect the rear link joint and attach the
locking spring.
11. Tighten the rear link joint's lock nut.
12. Check the settings of the neutral position
contact. See "Micro Switch Pedal
Arrangement" on page 112.
13. Fasten the hydrostatic transmission
cables with a plastic tie.
14. Screw on the frame plate, two screws.
15. Test drive the machine forwards and in
reverse. If the machine drives in neutral
the spring's cams may be adjusted
incorrectly.
70
English-
REPAIR INSTRUCTIONS
Locking spring
Fastening with a plastic tie
Frame plate
The spring's cams
8009-203
~80
6019-019
8009-340
8009-740