Husqvarna Rider Pro 18 AWD Workshop Manual page 101

9. Unhook the height adjustment strut (E)
by moving the rear part upwards:
Unload the strut if necessary by pulling
the frame's forward section up or down.
10. Pull the handle (D) and unit
simultaneously. Release the handle
when the unit has come out a bit.
11. Pull out the unit so that it catches on the
outer hooks.
In this position, the unit can be set in the
service position, when required.
12. Lower the unit with the mechanical lifting
lever.
13. Pull the handle (D) so that the safety
catch locks. Check that the catch (A) is in
the inset position.
14. Remove the unit from the machine.
REPAIR INSTRUCTIONS
Height adjustment strut
Pull forward
Pull to the stop position
Locking the safety catch
8009-169
8009-170
8009-024
8009-171
99
English-