Table of Contents
Advertisement
Checking and Adjusting the Choke
Cable
The picture shows ProFlex 21. For Pro 18,
see "Fitting the Engine" on page 37.
If the engine produces black smoke or is
difficult to start, this can be because the
choke cable is incorrectly adjusted (upper
cable).
If adjustments are necessary, they can be
made as follows:
1.
Loosen the clamping screw for the
cable's outer casing and move the choke
lever to the full choke position.
2.
Check that the choke cable is mounted in
the upper lever, see illustration.
3.
Pull the choke cable's outer casing as far
to the right as possible and tighten the
clamping screw.
Replacing the Articulated Steering Bearings
1.
Remove the engine as previously
described "Removing the Engine" on
page 35.
2.
Jack up the rider in front of the
articulated steering.
3.
Remove the belt guide and skid guard if
fitted.
4.
Pull off the drive belt from the engine's
belt side.
REPAIR INSTRUCTIONS
Choke cable
Jacking up
Belt guide
8009-607
6012-023
8009-736
47
English-
Advertisement
Table of Contents
