Fitting the Cutting Unit ProFlex
!
WARNING!
Exercise caution.
Risk of crush injuries
Starting point for attaching the cutting unit:
•
Place the machine on a flat surface.
•
Lock the brake by pressing down the
pedal and locking with the push-button.
•
Equipment hydraulics in the lower
position on ProFlex 21.
•
Equipment frame in lowered position.
•
Equipment frame locked with safety
catch and locks (A) in the inset position.
•
Unit frame mounted on the cutting unit,
see "Dismantling the Equipment Frame
ProFlex" on page 100.
1.
Attach the unit to the equipment frame's
outer hooks.
2.
Pull out the catch (A) and loosen the
safety catch by pushing its handle (D)
back.
3.
Raise the unit by pulling up the
mechanical lifting lever, located on the
driver's right side.
4.
Push the unit in so that the interior plugs
(B) touch the bottom of the equipment
frame's grooves.
REPAIR INSTRUCTIONS
Outer hooks
Lock and safety catch
Inner pins
8009-024
D
A
8009-167
8009-018
93
English-