Fitting the Pendulum Shaft
1.
Lubricate half the shaft (the half that has
not been machined) and press it into the
steering spindle from the rear (see
illustration).
2.
Fit the washer and circlip on the
pendulum shaft by the inner mount.
3.
Fit the dust cover (with thin lip towards
the rear) approx. 2/3 of the way in on the
shaft and lubricate the shaft on both
sides of the dust cover.
4.
Roll the rear frame forward and press it
onto the pendulum shaft.
5.
Fit the washer and circlip on the
pendulum shaft (1).
6.
Connect the hydraulic hose to the
hydrostatic transmission.
7.
Fit the pump unit, see "Pump Unit" on
page 52.
8.
Check that the controls and cables are
properly adjusted, see, "Adjusting the
Hydrostatic Transmission Cable" on
page 46.
9.
Check the neutral position contact and
adjust if necessary. See "Micro Switch
Pedal Arrangement" on page 112.
10. Bleed the hydraulic system of excess air.
Top up the oil as needed after test
running.
11. Fit the transmission cover.
REPAIR INSTRUCTIONS
Fitting the pendulum shaft
6012-098
51
English-