Table of Contents
Advertisement
Adjusting the Hydrostatic
Transmission Cable
The hydrostatic transmission cable (on the left
side) is adjusted in the following manner:
1.
Remove the transmission cover. Loosen
both screws (one on each side) and lift off
the transmission cover.
2.
Take apart the ball joint, which is locked with
a locking spring.
3.
Ensure that the forward drive pedal is
pressed down completely.
4.
Switch the vertical arm to the maximum
position and check that the ball and socket
in the ball joint are aligned.
5.
Adjust the socket on the cable as needed,
so that it fits precisely over the ball on the
lever arm.
6.
Assemble the ball joint.
7.
Put the ball joint's locking spring in place.
8.
Tighten the lock nut for the socket on the cable.
IMPORTANT INFORMATION
Make sure that the locking spring goes
through both holes in the socket.
Checking and Adjusting the Throttle
Cable
The picture shows ProFlex 21. For Pro 18, see
"Fitting the Engine" on page 37.
Check that the engine responds to throttle
increases and that a good engine speed is
attained at full throttle.
If adjustments are necessary, they can be made
as follows for the lower cable:
1.
Loosen the clamping screw for the cable's
outer casing and move the throttle to the full
throttle position.
2.
Check that the throttle cable is mounted in the
correct hole in the lower lever, see illustration.
3.
Push the throttle cable's outer casing as far
to the left as possible and tighten the
clamping screw.
46
English-
REPAIR INSTRUCTIONS
Transmission cover
Checking the adjustment of the hydrostatic transmission
cable
The link joint's locking spring
Throttle cable
8009-603
8009-646
8009-203
8009-606
Advertisement
Table of Contents
