Table of Contents
Advertisement
7.
Loosen the stop screws (2) and remove
the bearing on right-hand side.
Assembly
1.
Assemble the rear axle in the reverse
order in relation to dismantling. The
bearing on the right-hand side is turned
so the grease nipple points backwards.
Tighten the right-hand side bearing
before the left side bearing.
2.
The stop screws for the bearing on right-
hand side are tightened after the five
screws holding the rear axle have been
tightened.
3.
Grease the axles for protection against
corrosion before the wheels are fitted.
4.
Fill with oil and vent the entire hydraulic
system according to "Bleeding the
Hydrostatic and Hydraulic Systems" on
page 71.
5.
Check and adjust the speed coordination
between the front wheels and rear
wheels according to the separate
instruction.
Synchronising Front and Rear Wheel
Drives
The front and rear wheel drives must be
synchronised so that when cornering the
front wheels run at a higher speed than the
rear wheels. When driving straight forwards
all wheels should rotate at the same speed.
In order to avoid measurement error due to
rollback on the differential wheels, two of the
machine's wheel must make contact with the
ground.
Ensure the steering wheel position does not
change while work is in progress.
1.
Check that the synchronisation link is
fitted in the upper hole on Pro 18 AWD
and in the lower hole on ProFlex 21
AWD.
REPAIR INSTRUCTIONS
Stop screws
Synchronisation link
8009-661
8009-693
61
English-
Advertisement
Table of Contents
