5.
Remove the locking spring and loosen
the throttle control's link joint locking
spring, and remove the cable's bracket
from the rear frame and the hydraulic
pump's ball joint.
6.
Clean, see "Working Methods" on
page 114. Mark and remove the
hydraulic hoses from the couplings
under the machine.
7.
Loosen the steering cables (1) and
remove the steering collar.
8.
Remove the belt pulley (2). Move the
lower part forwards, the upper part
backwards, and force the pulley out.
!
WARNING!
The centre spring is under
extremely high tension and can
cause injuries if it flies off. Wear
protective eyewear and gloves
when removing or fitting the
spring.
9.
Loosen the centre spring. This spring is
under high tension and the load should
be relieved with the help of tool number
506 89 93-01.
10. Remove the screw for the centre spring's
rear mounting after the load on the
spring has been relieved.
48
English-
REPAIR INSTRUCTIONS
Locking spring
Steering cables and belt pulley
Relieving load on centre spring.
The centre spring's rear mounting
8009-203
8009-367
8009-517
6012-026