Ignition And Starter Lock; Hour Meter; Fuses - Husqvarna Rider Pro 18 AWD Workshop Manual

Ignition and Starter Lock

1. Remove the right-hand side cover from
the lever housing.
2. Release the connector from the ignition
lock by pulling it straight down.
3. Remove the ignition key and the rubber
seal.
4. Remove the nut and the ignition lock.
5. Assemble the parts in the reverse order.
Make sure the connector ends up in the
proper position (click-lock).

Hour Meter

1. Remove the right-hand side cover from
the lever housing.
2. Release the cables from the hour meter.
3. Drill out the rivets attaching the hour
meter from above.
4. Assemble the parts in the reverse order.
The chronometer may be attached with
nuts, bolts, and spring washers if suitable
rivets are unavailable.

Fuses

The main fuse is placed in a detachable
holder under the battery case's cover, in front
of the battery.
Type: Flat pin, 15 A.
The fuse for the power outlet is placed under
the ignition switch, behind the side plate on
the control panel.
Type: Flat pin, 7,5 A.
Do not use any other type of fuse when
replacing.
A blown fuse is indicated by a burnt
connector. Pull the fuse from the holder when
replacing.
The fuse is there to protect the electrical
system. If it blows again shortly after
replacement, it is due to a short circuit, which
must be fixed before the machine can be put
into operation again.
ELECTRICAL SYSTEM
Ignition and Starter Lock
Hour meter
Main fuse
Fuse power outlet
8009-397
8009-398
8009-370
8009-610
109
English-