Husqvarna Rider Pro 18 AWD Workshop Manual page 41

6. Note: The AWD-machines are equipped
with a radiation guard plate under the
muffler. Position this before the protective
plate is fitted.
Attach the cover plate over the muffler,
two screws on each side of the muffler.
7. Press the fuel hose into place against the
fuel pump and attach the hose clamp.
8. Screw the cable from the starter to the
start relay into place.
Attach the engine's electrical connectors.
IMPORTANT INFORMATION
Hold the battery cable bolts in place so that
the electrodes are not strained.
9. Lift the battery into position and attach
the cable connectors and cover, tighten
the fastening strap.
REPAIR INSTRUCTIONS
The muffler's protective plate
Fuel pump
The engine's electrical connections
Battery installation
8009-035
8009-191
8009-190
8009-427
39
English-