Adjusting An Absolute Encoder - Siemens SINAMICS V90 Operating Instructions Manual

Basic operator panel (BOP)
6.5 Auxiliary functions
6.5.7

Adjusting an absolute encoder

Note
Motor type
This function is only available when you are using a servo motor with the absolute encoder.
Stop the servo motor
You must stop the servo motor before adjusting the absolute encoder.
With the BOP function menu "ABS", you can set the current position of an absolute encoder
to the zero position. To do this, proceed as follows:
Note
Save parameter
The position value is set in parameter p2525. You must save the parameters after setting the
zero position.
158
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2020, A5E37208830-008