Brush Drive Configuration (Ds16020 Or Ds16030); Figure 2-4. Ds16020 / Ds16030 Brush Drive Modules - Aerotech DR500 Operation & Technical Manual

DR500 Operation and Technical Manual

2.2.5. Brush Drive Configuration (DS16020 or DS16030)

To configure a slot in the DR500 for a brush drive module (refer to Figure 2-4 for
DS16020 and DS16030), proceed with the following steps:
•
Set jumpers and drive key according to DS16020/DS16030 Brush Drive
configuration (Table 2-4).
To minimize the risk of electrical shock and bodily injury, ensure that all electrical
power switches are in the off position and disconnect main power for 1 minute before
inserting/removing drive modules or changing jumper configurations.
To prevent another drive type from being inadvertently inserted into a slot configured for
another type of drive module, the mating drive connector on the motherboard should have
a key (Aerotech part number EAM857 otherwise Schroff #21101-252) inserted into slot
B. Refer to Figure 2-3.
Figure 2-4.
Version 1.6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DS16020 / DS16030 Brush Drive Modules
Aerotech, Inc.
Set Up
WARNING
2-11