Table of Contents
Advertisement
DR300 Operation and Technical Manual
2.2.6. DS16020 / DS16030 Brush Drive Configuration
To configure a slot in the DR300 for a brush drive module (Figure 2-4), proceed with the
following steps:
•
Set jumpers and Drive key according to DS16020 /DS16030 Brush Drive
Configuration Table 2-4.
To minimize the risk of electrical shock and bodily injury, ensure that all electrical
power switches are in the off position and disconnect main power.
To prevent another drive type from being inadvertently inserted into slot B, the mating
drive connector on the motherboard should have a key (Aerotech part number EAM857
otherwise Schroff #21101-252) inserted into slot B. Refer to Figure 2-3.
Figure 2-4.
Version 1.5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DS16020 / DS16030 Brush Drive Modules
Aerotech, Inc.
Set Up
WARNING
2-11
Advertisement
Table of Contents
Troubleshooting
