DR500 Operation and Technical Manual
5.5.
Preventative Maintenance
The DR500 and external wiring should be inspected monthly. Inspections may be
required at more frequent intervals, depending on the environment and use of the system.
Table 5-4 lists the recommended checks that should be made during these inspections.
Table 5-4.
Preventative Maintenance
Check
Visually Check chassis for loose or
damaged parts / hardware.
Note: Internal inspection is not
required.
Inspect cooling vents.
Check for fluids or electrically
conductive material exposure.
Visually inspect all cables and
connections.
Version 1.6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Action to be Taken
Parts should be repaired as required. If internal
damage is suspected, these parts should be
checked and repairs made if necessary.
Remove any accumulated material from vents.
Any fluids or electrically conductive material
must not be permitted to enter the DR500 and
should be removed immediately.
Note: Disconnect power to avoid shock hazard.
Tighten or resecure any loose connections.
Replace worn or frayed cables. Replace broken
connectors.
Aerotech, Inc.
Troubleshooting
5-5