External Device Power; Mechanical Installation - Aerotech DR500 Operation & Technical Manual

Set Up
2.5.
The 5 volt source for the joystick, pin 19 of the Misc. I/O connector, the encoder and
limit switch power sources on the axis encoder connectors (if configured for 5 volt
operation), and pin 25 of the I/O bus connector are fused by a re-settable fuse located on
the interface board. Turning off power for approximately 30 seconds resets this fuse
(remove shorts overloads from +5V before turning power on).
2.6.
The DR500 Rack Mount package is designed to be mounted into a standard 19" rack. The
Desktop package can be placed on desk or bench top. Allowance must be made for the
rear panel connections and cables.
Serial Tag
AEROTECH
World Headquarters:
101 Zeta Drive
Pittsburgh, PA 15238 USA
USA: (412) 963-7470 Sales FAX: (412) 963-7459
USA Service FAX: (412) 963-7000
UK: 0734-817274 FAX: 0734-815022
Deutschland: 0911-52031 FAX: 0911-5215235
AXIS 4
NOTE: The connectors for motor power are made with (Amp 206044-1, 206070-1, and pins 66098-7)
2-30
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DR500 Operation and Technical Manual

External Device Power

Mechanical Installation

16in/8out Digital I/O and/or Hall Effect Signals,
XIO cable or equivalent from Controller
Digital I/O cable to Opto 22, PB8, PB16 or PB24 Racks
(left) Encoder Input 1
(left) Encoder Input 3
Emergency Stop, Interrupts, Analog I/O
Redundant amplifier signals, external +12 VDC @ 500mA
(left) Joystick Interface
100 Cond Cable to Controller
AXIS 3 AXIS 2
W
Indicates protective grounding connection
Figure 2-15. DR500 Rear Panel Connector Layout
Refer to Chapter 3 for rack mount and desktop package dimensions.
Aerotech, Inc.
I/O BUS POWER OK
(right) Encoder Input 2
ENCODER 1 POWER OK
(right) Encoder Input 4
ENCODER 3 POWER OK
(right) Brake Control
AXIS 1
FROM CONTROLLER P5 1
J10
I/O BUS 1
J11
AXIS 1 1 AXIS 2 1
J2 J3
ENCODER 2 POWER OK
AXIS 3 1 AXIS 4 1
J4 J5
ENCODER 4 POWER OK
MISC I/O 1
J13
JOYSTICK 1 BRAKE 1
J12 J14
FROM CONTROLLER P1 1
J1
Version 16