Electrical Specifications; Fault Output - Aerotech DR500 Operation & Technical Manual

Set Up
2.2.5.1.
Electrical specifications are listed in Table 2-7.
Table 2-7.
Peak Current Output (2 sec)
Continuous Output Current
Output Fuse, F1 (3 AG, slow blow)
Peak Output Voltage
Minimum Voltage Output
Peak Power Output
Continuous Power Output
Efficiency
Voltage Gain (max open loop)
Drift (referred to input)
Offset
Gain (continuous output)
Bandwidth
PWM Switching Frequency
Output Current Limit
Shutdown Input
Minimum Load Inductance
Operating Temperature
Storage Temperature
Weight
Two control sections (pre-amplifier and post-amplifier, in dotted lines) are shown in
Figure 2-5. These control sections are detailed in Figure 2-6 and Figure 2-9.
2.2.5.2.
The Servo Amplifier Module may be selectively configured for a Fault Output of active
high. This is accomplished by removing the Fault Output Select jumper (see Figure 2-5)
from JP1-1 to 2 and connecting the jumper to JP1-2 to 3 (both are P.C.B. trace jumpers).
2-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DR500 Operation and Technical Manual

Electrical Specifications

DS160 Series Electrical Specifications
Units
Amps
Amps
Amps
Volts
Volts
Watts
Watts
%
Pre-Amplifier
dB
µV/°C
Volts
Power Amplifier
Amps/Volt
kHz
kHz
Amps (max)
mH
°C
°C
kg (lb)

Fault Output

Aerotech, Inc.
DS16020 DS16030
±20 ±30
±10 ±15
(± 5 without fan) (± 5 without fan)
10 (5 w/o fan) 15 (5 w/o fan)
160 160
10
2920 4200
1530 2300
(765 w/o fan) (765 w/o fan)
93
100
10
Adjustable to Zero
1
1
20
Adjustable: Zero to Peak
Tristates Motor Output
2
0 to 50
-30 to 85
0.5 (1)
Version 16
10
2