Uc360 Web Server - Mitel UC360 Administration Manual

UC360 Web Server

The Remote Diagnostic Web Application allows you to access debug and diagnostics through
a web service on the UC360. See "Web Server Settings" on page 48 for information on how to
enable this service. It is disabled by default.
1. Enter the IP address of the UC360 unit you wish to access in a web browser.
The landing page shows some basic information about the UC360 unit to confirm that you
have accessed the correct unit.
2. Next, Click Diagnostics.
This action loads the diagnostics using a secure HTTPS link and a security warning will be
presented by the browser unless the Mitel Root Certificate is installed.
You may chose to ignore the security warning and proceed, but will likely be issued with
the warning each time you access diagnostics or your browser may allow you to add a
security exception. Installing the Mitel Root CA is only done once for your browser and will
allow the browser to authenticate any UC360 or any other Mitel signed server without
continual security warnings.
- Click on the link Install the Mitel Root Certificate at the bottom of the landing page.
- This action opens a page "Installing the Mitel Root Certificate" that describes how to
download and install a Mitel Root Certificate on Firefox, IE, Opera and Chrome.
- Install the Mitel Root Certificate following the instructions provided.
3. If the username and password have not already been entered, you will see a login page
(again over HTTPS).
Enter the user name and password and click Login.
The main diagnostics page is displayed.
Note that there is currently only a single valid username - admin. The password is the same
used to access Advanced Settings.
UC360 Web Server
89