Debug Settings - Mitel UC360 Administration Manual

Debug Settings

1. Press Settings
2. Press Advanced.
3. Press System Settings.
4. Press Debug Settings.
You have the following options:
• Debugging - By default, debug logging is enabled.
• Logging Level - Warning is the default Logging Level.
• Kernel Messages - Enabled
• Debug log size
• Automatic Ethernet Trace - automatically starts an ethernet trace when network congestion
occurs (default is disabled).
• Manual Ethernet Trace - starts an ethernet trace when the user presses the Start Ethernet
Trace button (default is disabled).
- When enabled, UC360 will invoke a tcpdump to capture an Ethernet trace when
network impairment is detected and/or manually (on demand by the user).
- Logging level elevated during capture duration.
- Ethernet trace duration: 60 seconds or 100MB (whichever comes first).
- Last five captures are retained.
- Traces are copied to SD card through existing log copy mechanism.
• Copy Logs to SD - copies logs to an SD card.
• Copy Logs to USB Flash Drive - copies logs to a USB flash drive.
Note: Do not exit Settings while copying logs to the SD card or USB flash drive.Doing so
will interrupt the copying process and it will not complete.
• Development - for internal use only
• Custom Video Settings - for debug purposes and not recommended to be used
• Legacy Interop Mode - this option is used if the UC360 is experiencing problems interop-
erating with non-Mitel based servers. By default, this setting is not enabled. Do not enable
it unless advised by Mitel Technical Support. While troubleshooting, it is also recommended
to enable H.264 base profile to improve interoperation with non-Mitel based servers.
• Always mirror primary display to HDMI - this option allows the UC360 to mirror the UC360
on the HDMI display is for demo and training purposes only.
.
UC360 Configuration
47