Mitel UC360 Administration Manual page 51

Setting up the AXIS Camera
It is recommended that you use the AXIS IP Utility and AXIS Camera Management to set up
the AXIS camera. These free applications are available on the AXIS Network Product CD
supplied with the camera, or can be downloaded from www.axis.com/techsup. See your AXIS
Camera Installation Guide for more details.
If you are using an Axis camera, depending on when you purchased the camera, it may be
necessary to reinstall the camera's firmware. It may require an upgrade or a downgrade to
ensure that the Axis camera is running the exact revision of firmware shown. If necessary you
can obtain a copy of the required firmware at Mitel On-Line.
For the Axis camera, if you have upgraded from pre-5.40 firmware to 5.40.9.2 or newer, you
must do the following:
• perform a factory restore on the camera and setup an ONVIF user for security
• add the username and password to the UC360 Camera Settings
Perform Factory Restore on Axis Camera
1. Open AXIS Camera Management software.
2. Select the Setup Menu.
3. Go to System Options -> Maintenance.
4. Click Restore.
Wait a few minutes for the camera to reset. After the camera has rebooted, login again.Now
you must add the ONVIF user.
Create an ONVIF User in Axis
1. In Axis Camera Management, access the Setup Menu.
2. Go to System Options -> Security.
3. Click ONVIF.
4. Add a user: enter the username, password, and select Administrator as the User Group.
This is the username and password to be used in the UC360 Camera Settings.
UC360 Configuration
35