SD Card Upgrade
The SD Card must contain the file named upgrade.xml and the upgrade file package, typically
named update.zip, in the top-level folder. Mitel will supply these files with each new software
load. The upgrade.xml file name will contain the new software load version.
1. Insert the SD Card with the software upgrade.
2. Press Settings
3. Press System Settings.
4. Select Upgrade system S/W.
5. Select Upgrade system S/W now.
6. Select SD Card.
You will see a series of messages. This can take several minutes; the UC360 will power
off and then on. The UC360 will reboot and load the new software.
7. Unmount the USB flash drive or SD Card (see "Unmount SD Card or USB Flash Drive" on
page 42)
Note: You can abort the software upgrade by pressing the Home
HTTP Server Upgrade
1. Press Settings
2. Press System Settings.
3. Select Upgrade system S/W.
4. Select HTTP Server Address and enter the IP address of the HTTP server where new
software loads are stored.
5. Press Save.
6. Select Upgrade system S/W now.
7. Select HTTP.
You will see a series of messages. This can take several minutes; the UC360 will power
off and then on. The UC360 will reboot and load the new software.
, then press Advanced.
, then press Advanced.
UC360 Configuration
button.
45