Pcg-Change Pin; Phs-Picture-In-Picture Horizontal Size; Pif-Projector Information - Christie DWU1612-HS Technical Reference

PCG–Change Pin
Changes the personal identification number (PIN) on a projector.
Commands
Command
PCG "<00000,NNNNN>"
Examples
Replace the default PIN number with a new PIN:
(PCG "12345,78564")
PHS–Picture-in-Picture Horizontal Size
Sets the size (width) of the picture-in-picture/picture-by-picture window.
The active portion of the input signal, as determined by blanking controls, is scaled to fit into the
picture-in-picture window.
Commands
Command Description
PHS? Displays the picture-in-picture size. (Read-only)
PHS <value> Sets the picture-in-picture/picture-by-picture size.
Examples
Set the picture-in-picture size to large:
(PHS 2)
PIF–Projector Information
Displays information about the projector.
This command is only available when the projector is in service mode and is read-only.
DWU1612-HS/DWU2022-HS Technical Reference–Serial Commands
020-103352-01 Rev. 1 (03-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Replaces the existing PIN number, where:
• 00000 = Previous PIN
• NNNNN = New PIN
Serial API commands
Values
Valid PIN number
12345 (Default)
Values
—
0 = Small
1 = Medium
2 = Large (Default)
52