Cautions On Using Transparent Port (2-Port) Function Of Got-F900 Series - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
5.5 Cautions on using transparent port (2-port) function of GOT-F900
Series
When monitoring circuits, device registration, etc. in an FX
using the transparent (2-port) function in the GOT-F900 Series, make sure to execute the following setting.
If the following setting is not provided, write to PLC, read from PLC, verify with PLC, etc. operate normally, but
monitoring (ladder monitor, entry data monitor, etc.) cannot be normally executed.
When directly
connecting GX Developer
to PLC
When using transparent
function in GOT-F900
Series
Setting in GX Developer (Ver. 8.22Y or later)
1. Select [Online]
2. Double-click [PLC module] in [PLC side I/F] to open the [PLC side I/F Detailed setting of PLC
module] dialog box.
3. Put a check mark to the check box [via GOT-F900 transparent mode] as shown below
A display screen is the example of Ver. 8.72A.
4. Click the [OK] button to finish the setting.

5.5 Cautions on using transparent port (2-port) function of GOT-F900 Series

GX Developer Ver. 8.12N or earlier GX Developer Ver. 8.22Y or later GX Developer Ver. 8.72A or later
Set "COM port" and "Transmission
speed" on "PC side I/F Serial
setting" dialog box.
Setting shown below is not required.
[Transfer setup...] to open the "Transfer Setup" dialog box.
Double-click it.
5 Version Information and Peripheral Equipment Connectability
PLC from GX Developer Ver. 8.72A or later
3G
Select "RS-232C" on "PC side I/F
Serial setting" dialog box, and set
"COM port" and "Transmission
speed."
Setting shown below is
required.
Put a check mark to the
check box "via GOT-F900
transparent mode."
Select "RS-232C" on "PC side I/F
Serial setting" dialog box, and set
"COM port" and "Transmission
speed."
Select "RS-232C" on "PC side I/F
not
Serial setting" dialog box, and
execute setting shown below.
65
1
2
3
4
5
6
7
8
9
10