Connecting Method C - Connection Of Special Adapter; Connecting Method D - Connection Of Powered Extension Units/Blocks To Main Unit - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
8.6.4

Connecting method C - connection of special adapter

When connecting the special adapter, it is necessary to attach the connector conversion adapter before the
special adapter using the method described in the preceding subsection.
1
Slide the special adapter connecting hooks
(A in the right figure) of the main unit.
• When adding a special adapter to the special adapter that
has been connected to the connector conversion adapter,
read "connector conversion adapter" as "special adapter."
(This applies to the following steps.)
2
Connect the special adapter (B in
the right figure) to the connector
conversion adapter as shown in the
right figure.
3
Slide the special adapter connecting
hooks (A in the right figure) of the
connector conversion adapter to
secure the special adapter (B in the
right figure).
Caution
When using the FX
8.6.5

Connecting method D - connection of powered extension units/blocks to main unit

The procedures for connecting an powered extension unit/block to the main unit are explained below.
1
Remove the extension device connector
cover (A in the right figure) on the right side
of the main unit.
2
Connect the extension cable (B in the right
figure) from the extension block to be con-
nected (right side) to the extension device
connector of the main unit.
• When connecting FX
be added (right side) and the existing unit (main unit) with the supplied extension cable.
3
Fit the extension device connector cover (A in the right figure).
-ENET-ADP, connect it to the last adapter position (leftmost position).
3U
Series input/output powered extension unit or FX
2N
8.6 Connecting Methods for Main Unit and Extension Devices
1
A
A
3
B
2
2
2
-1PSU-5V, connect the unit to
3U
8 Installation In Enclosure
1
A
3
A
A
3
B
1
119
1
2
3
4
5
6
7
8
9
10