Mitsubishi Electric MELSEC-F FX3G Series User Manual page 67

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
• Japanese version
Programming tool
*1
GX Works2
(SW DNC-GXW2-J)
*2
GX Developer
(SW D5C-GPPW-J)
*2
FX-PCS/WIN
*1. Write during RUN is not possible with a SFC program.
*2. Write during RUN is not possible with a list program or a SFC program.
Cautions on write during RUN
Item
Program memories which can be
written in RUN mode
• GX Works2
Ver. 1.08J or later
Number of
• GX Developer
program steps
Ver. 8.72A or later
which can be
written for
• GX Developer
circuit change
Ver. 8.70Y or
in RUN mode
former
• FX-PCS/WIN(-E)
Circuit blocks which cannot be written
in RUN mode
*1. Circuit blocks cannot be edited to insert a label as shown below when written during RUN.
Version
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 1.07H or later
earlier than Ver. 1.40.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 1.56J or later
Ver. 1.40.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 2.00A or later
Ver. 1.00.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 5.00A or later
Ver. 1.00.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 8.72A or later
earlier than Ver. 1.10.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 8.76E or later
Ver. 1.10.
Writing in the instruction and device ranges during RUN is supported in FX
Ver. 4.00 or later
Ver. 1.00.
Built-in EEPROM and optional memory cassette (whose write protect switch is set to OFF)
256 steps or less after edition (addition/deletion) (including NOP
immediately after circuit blocks except final circuit)
127 steps or less after edition (addition/deletion) (including NOP
immediately after circuit blocks except final circuit)
*1
Circuit blocks in which labels P and I are added, deleted or changed in edited circuits
Circuit blocks in which 1-ms timers (T246 to T249 and T256 to T319) are added in edited circuits
Circuit blocks in which the following instructions are included in edited circuits
• Instruction to output high-speed counters C235 to C255 (OUT instruction)
• TBL (FNC152) instruction
Step
FNC 04
0
EI
FNC 06
FEND
Pointer for
interrupt
Label I is inserted by editing the circuit block
I001
FNC 03
IRET
END
5 Version Information and Peripheral Equipment Connectability
5.2 Programming Tool Applicability
Remarks
Caution
Added, deleted, or changed
Added, deleted, or changed
1
3G PLCs
PLCs
3G 2
2N PLCs
PLCs
1N
3G PLCs
3
PLCs
3G
PLCs
1N
4
5
6
7
8
9
10
61