16Eyt-C (Transistor Output); Product Specifications - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
16.11 FX -8EYT, FX
2N

16.11.1 Product specifications

The generic specifications are identical to the main unit specifications.
For external wiring, refer to the following chapters.
1. Power supply specifications
Item
Product type
Rated voltage
2. Weight and Other specifications (External dimensions are described later.)
Item
MASS (Weight)
Other
3. Output specifications (Transistor output type)
Item
Output Points
Connection type
Output unit/type
External power supply
Output circuit insulation
Indication of output operation
Resistance load
Max. load
Inductive load
Open circuit leakage current
Min. load
OFF ON
Response time
ON OFF
Output circuit configuration
16.11 FX2N-8EYT, FX2N-16EYT, FX2N-16EYT-C (Transistor Output)
-16EYT, FX

-16EYT-C (Transistor Output)

2N 2N
FX -8EYT
2N
FX 2N extension block
24V DC (supplied from main unit and input/output powered extension unit)
FX -8EYT
2N
Approx. 0.2kg (0.44lbs)
• The extension cable is already connected to the extension block.
• Accessories: Label for indication of input/output number
• The DIN46277 rail (width: 35 mm (1.38")) or direct installation.
FX 2N -8EYT
8 points
Vertical terminal block (M3 screws)
Activation of the photo-coupler will light the LED indicator lamp on panel.
0.5A/point
The total load current per common should be
as follows:
• 4 output points/common: 0.8A or less
• 8 output points/common: 1.6A or less
12W/24V DC
The total of inductive loads per common
terminal should be the following value.
• 4 output point/common terminal: 19.2W or
less/24V DC
• 8 output points/common terminal: 38.4W or
less/24V DC
Load
Fuse
COM1
DC power
supply unit
Fuse
COM2
DC power
supply unit
→ Refer to Section 4.1 for generic specifications.
→ Refer to Chapter 12 for output wiring.
FX -16EYT
2N
FX
FX -16EYT
2N
Approx. 0.3kg (0.66lbs)
FX 2N -16EYT
16 points
Transistor/sink output
5-30 V DC
Photo-coupler insulation
The total load current per common should be
as follows:
• 16 output points/common: 1.6A or less
The total of inductive loads per common
terminal should be the following value.
• 16 output points/common terminal: 38.4W
or less/24V DC
0.1mA/30V DC
-
0.2ms or less for 200mA (at 24V DC)
0.2ms or less for 200mA (at 24V DC)
Y
Fuse
DC power
supply unit
Y
Fuse
DC power
supply unit
16 Input/Output Extension Blocks
FX -16EYT-C
2N
2N connector type extension block
FX -16EYT-C
2N
FX 2N -16EYT-C
Connector terminal block
0.3A/point
7.2 W/24V DC
Load
Y
COM
Y
COM
279
11
12
13
14
15
16
17
18
19
20