Specifying A Hexadecimal Current Value Display Format; System Information - Specifying A Hexadecimal Current Value Display Format; Program Example 1 (Specifying A Hexadecimal Data Display Format); Program Example 2 (Specifying A Decadal Data Display Format) - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition

19.18 Specifying a Hexadecimal Current Value Display Format

The procedure for specifying a hexadecimal display format for current values which display at the "Monitor/
Test" menu explained below. The display format is specified by the system information's (system signal 2)
"M +8" ON/OFF status.
The display formats which correspond to the ON and OFF statuses are shown in Section 19.13 below. The
display format should either be fixed as decimal or hexadecimal. Switching between the two should be
possible by an external operation.

19.18.1 System information - specifying a hexadecimal current value display format

1. System signal 1
System signal 1 is unrelated to this function.
2. System signal 2
System
Information
M +8

19.18.2 Program example 1 (specifying a hexadecimal data display format)

The following program example specifies a hexadecimal display format for current values and setting values
which display at the "Monitor/Test" screen. In this program example, system information is assigned from D50
to D54 and from M50 to M64.
M8002
Initial pulse
M8000
RUN monitor

19.18.3 Program example 2 (specifying a decadal data display format)

The following program example specifies a decimal display format for current values and setting values which
appear at the "Monitor/Test" screen. In this program example, system information is assigned from D50 to
D54 and from M50 to M64.
M8002
Initial pulse
M8000
RUN monitor
352
Setting Display
Content Format
Hexadecimal Timer (T) [current value/setting value], counter (C) [current value/setting value], data
ON
register (D) [16-bit/32-bit], extended register (R) [16-bit/32-bit], and extended file register
OFF Decimal
(ER) [16-bit/32-bit]
MOV K50 D8300
MOV K50 D8301
M58
END
MOV K50 D8300
MOV K50 D8301
M58
19.18 Specifying a Hexadecimal Current Value Display Format
→ Refer to Section 19.13 for system information setting.
Display Subjects
System information (system No.1) is set at D50 to D54.
System information (system No.2) is set at M50 to M64.
Specifies a hexadecimal display format for current values which appear
at the Monitor/Test screen.
System information (system No.1) is set at D50 to D54.
System information (system No.2) is set at M50 to M64.
Specifies a decimal display format for current values which appear at
the Monitor/Test screen.
19 Display Module (FX3G-5DM)