Alcatel-Lucent H2 DeskPhone User Manual page 70

H2 DeskPhone
H2P DeskPhone
◼ L2TP
NOTE: The device only supports non-encrypted basic authentication and non-encrypted data
tunneling. For users who need data encryption, please use OpenVPN instead.
To establish an L2TP connection, users should log in to the device web portal, open the web page and go to
[Network] >> [VPN]. In VPN mode, check the "Enable VPN" option and select "L2TP", then fill in the L2TP
server address, authentication username, and authentication password in the L2TP section. Press "Apply,"
and then the device will try to connect to the L2TP server.
When the VPN connection is established, the VPN IP address should be displayed in the VPN status. There
may be a delay in establishing the connection. The user may need to refresh the page to update the status.
Once the VPN is configured, the device will try to connect with the VPN automatically when the device boots
up every time until the user disables it. Sometimes, if the VPN connection is not immediately established,
the user can try to reboot the device and check if the VPN connection is established after the reboot.
◼ OpenVPN
To establish an OpenVPN connection, the user should get the following authentication and configuration
files from the OpenVPN hosting provider and name them as follows:
OpenVPN configuration file:
CA root certification:
Client certification:
Client key:
The user then uploads these files to the device via the web page by going to [Network] >> [VPN] and
selecting OpenVPN Files. Then the user should check "Enable VPN" and select "OpenVPN" in VPN Mode
and click "Apply" to enable the OpenVPN connection.
Like the L2TP connection, the connection will be established every time the system reboots until the user
disables it manually.
10.6.2.4 Web server type
Configure the Web Server mode to be HTTP or HTTPS, and this will be activated after the reboot. Then the
user can use the http/https protocol to access the telephone's web page.
8AL90394ENAAed01
client.ovpn
ca.crt
client.crt
client.key
Figure 106 - Configuring the web server type
70 /111