Alcatel-Lucent H2 DeskPhone User Manual page 75

H2 DeskPhone
H2P DeskPhone
Server Firmware Version
[Upgrade] button
New version description
information
⚫ The file requested from the server is a TXT file called vendor_model_hw1_0.txt.Hw followed by the
hardware version number. It will be written as hw10 if there is no difference in the hardware. All spaces
in the filename are replaced by underlines.
The URL requested by the telephone is HTTP:// server address/vendor_Model_hw1_0
⚫
.txt: The new version and the requested file should be placed in the download directory of the HTTP
server, as shown in the figure below:
⚫ TXT file format must be UTF-8
⚫ vendor_model_hw1_0.TXT The file format is as follows：
Version= R100.2.10.00.0001020 #Software Version
Firmware=xxx/xxx.z
distinguished by the presence of protocol headers.
BuildTime=2018.09.11 20:00
Info=TXT|XML
Xxxxx
Xxxxx
Xxxxx
Xxxxx
⚫ After the interval of the update cycle arrives, if the server has available files and versions, the telephone
will prompt as shown below. Click [view] to check the version information and upgrade.
8AL90394ENAAed01
This will show the server firmware version.
If there is a new version txt and new software or firmware on the
server, the page will display the version information, and the
upgrade button will become available. Click the [Upgrade] button to
upgrade to the new firmware.
When there is a corresponding TXT file and version on the server
side, the TXT and version information will be displayed under the
new version description information.
#URL, Relative paths are supported and absolute paths are possible,
Figure 111 - Firmware upgrade
75 /111