Alcatel-Lucent H2 DeskPhone User Manual page 68

H2 DeskPhone
H2P DeskPhone
◼ IPv4
In IPv4 mode, there are 3 connection mode options: DHCP, PPPoE and Static IP.
When using DHCP mode, the telephone will get the IP address from the DHCP server (router).
⚫ Using DHCP DNS: This is enabled as the default. "Enable" means the telephone will get a DNS
address from the DHCP server, and "disable" means it will not.
⚫ Using DHCP time: This is disabled as the default. "Enable" means the time for getting the DNS
address from the DHCP server is managed, and "disable" means it is not.
When using PPPoE, the telephone will get the IP address from the PPPoE server.
⚫ Username: PPPoE username.
⚫ Password: PPPoE password.
When using Static IP mode, the user must configure the IP address manually.
⚫ IP address: telephone IP address.
⚫ Mask: sub mask of your LAN.
⚫ Gateway: the gateway IP address. The telephone can access the other network via this address.
⚫ Primary DNS: Primary DNS address. The default is 8.8.8.8, Google DNS server address.
⚫ Secondary DNS: When the primary DNS is not available, the secondary DNS will work.
◼ IPv6
In IPv6, there are 2 connection mode options, DHCP and Static IP.
The DHCP configuration refers to the IPv4 introduction on the last page.
⚫
⚫ A static IP configuration is almost the same as the one for IPv4, except for the IPv6 prefix.
⚫ IPv6 Prefix: IPv6 prefix, it is similar with mask of IPv4.
8AL90394ENAAed01
Figure 102 - DHCP network mode
Figure 103 - PPPoE network mode
Figure 104 - Static IP network mode
Figure 105 - IPv6 static IP network mode
68 /111