Network Configurations - Alcatel-Lucent H2 DeskPhone User Manual

H2 DeskPhone
H2P DeskPhone
Users must correctly enter the user name and password to log in to the web page. The default user name
and password are "admin/123456". For details of the web page operation, please refer to
configuration.

7.6 Network configurations

The device relies on an IP network connection to provide service. Unlike traditional telephone systems
based on a circuit switching technology, IP devices are connected to each other over the network and
exchange data on a packet basis based on the devices' IP addresses.
To enable this telephone, you must first correctly configure the network configuration. To configure the
network, users need to find the telephone function menu button [Setting] >> [Admin] >> [IP param].
The default password for Admin interface is "123456".
NOTE: If the user sees a 'WAN Disconnected' icon
network cable was not correctly connected to the device's network port. Please check if the cables
are connected correctly to the device, network switch, router, or modem.
The device supports three types of networks, IPv4/IPv6/IPv4&IPv6.
There are three common IP configuration modes in IPv4.
⚫ Dynamic Host Configuration Protocol (DHCP) – This is the automatic configuration mode acquired
through network configurations from a DHCP server. Users don't need to configure any parameters
manually. All configuration parameters will come from the DHCP server and be applied to the device.
This is recommended for most users.
⚫ Static IP – This option allows the user to configure each IP parameter manually, including the IP
Address, Subnet Mask, Default Gateway, and DNS servers. This is normally used in some professional
network user environments.
⚫ PPPoE – This option is often used by users who connect the device to a broadband modem or router.
To establish a PPPoE connection, the user should configure the username and password provided by
the service provider.
The device is configured in DHCP mode by default.
There are two common IP configuration modes in IPv6.
⚫ DHCP – This is the automatic configuration mode acquired via network configurations from a DHCP
server. Users need not configure any parameters manually. All configuration parameters come from the
DHCP server and are applied to the device. This is recommended for most users.
⚫ Static IP - This option allows users to manually configure each IP parameter, including the IP address,
mask, gateway, and primary and secondary domains. This is usually applied to certain professional
network user environments.
Please see 10.7.2.1 Network settings
8AL90394ENAAed01
flashing in the middle of screen, it means the
for detailed configuration and use.
11 Web
26 /111