Operating of the unit
5.1.2
GB - 22
Keyboard
When switching on KEB COMBIVERT the value of parameter CP.1 appears.
(See Drive mode to switch the keyboard function)
The function key (FUNC)
changes
between
parameter
value
and
parameter number.
With UP and DOWN the
value of the parameter
number is increased/
decreased with changeable
parameters.
Principally during a change, parameter values are immediately accepted and
stored non-volatile. With some parameters it is not useful, that the adjusted
value is accepted immediately. When this type of parameter is changed, then a
point appears behind the last digit.
By pressing ENTER the
adjusted value is accepted
and non-volatile stored.
If a malfunction occurs during operation, then the actual display is overwritten
by the alarm message. The alarm message in the display is reset by ENTER.
Error
With ENTER the error message is only reset in the display. In order
to reset the error itself, the cause must be removed and a reset on
terminal X1.20 (C-Version) / X1.14 (S-Version) or a power-on reset
must occur. In the Inverter status display (CP. 2) the error is still
displayed.
the
STOP
START
FUNC.
SPEED
STOP
START
ENTER
F/R
ENTER
F/R