The Drive Mode - KEB COMBIVERT M4 Instruction Manual

5.7
Start / Stop Drive
Change Direction of
Rotation
Preset Set Value
Leave Drive Mode

The Drive Mode

The drive mode is an operating mode of KEB COMBIVERT to start the drive
manually by the operator. After switching the control release the set value and
rotation presetting is done exclusively by the keyboard. In order to activate the
drive mode the corresponding password in CP.0 must be entered. The display
switches over as follows.
Direction of rotation
F=forward / r=reverse
Modulation blocked
Drive not controlled
START
Drive accelerates onto
the adjusted set value
STOP
START
To exit the drive mode the inverter must be in status "stop" (Display noP or LS).
Press the FUNC and ENTER keys simultaneously for about 3 seconds in order
to leave the drive mode. The CP-parameters appear in the display.
+
FUNC.
SPEED
Operating of the unit
noP = no control release /
LS = neutral position
Drive decreases to 0 Hz and
switches the modulation off
Drive changes direction
ENTER
of rotation
F/R
Display changes when key is pressed
FUNC.
to set value display/presetting
SPEED
Set value can be changed with
UP/DOWN at pressed FUNC/
SPEED key
ENTER
for 3 seconds
F/R
Status
STOP
Drive operates with
adjusted set value
GB - 33