Reference; Specifications - Banner PresencePLUS P1B65Q Instruction Manual

PresencePLUS Sensor P1B65Q
Supply Voltage and Current
22 to 26V dc; 250 mA max (exclusive of loads and the current required
by the PRC1 controller and optional LEDR140 light source)
Supply Protection Circuitry
Protected against reverse polarity and transient voltages
Array Size
512 x 384 CMOS pixel array
Output Configuration
Three SPST solid-state contacts which may be individually
programmed for either NPN (sinking) or PNP (sourcing)
Output Rating
50 mA max, each output
OFF-state leakage current < 100 µA
ON-state saturation voltage < 1V at 50 mA (NPN); < 2V at 50 mA (PNP)
bn
+
24V dc
bu
–
wh
load
bk
load
gy
load
pk
External Trigger
PNP Mode
Wiring Diagram
bu
–
24V dc
bn
+
wh
load
bk
load
gy
load
pk
External Trigger
NPN Mode

Specifications

Output Protection Circuitry
Protected against continuous overload or short circuit
Sensor Response Time
Each of the three outputs switch within 50 milliseconds from the leading
edge of the trigger input signal. Additional delay may be programmed.
Trigger Input
The sensor may be configured to accept either a current sinking (NPN)
or current sourcing (PNP) input. Internal pullup (NPN) or pulldown
(PNP) is provided:
NPN mode:
ON < 2V at 3 mA maximum
OFF >10V
PNP mode:
ON > 10V at 3 mA maximum
OFF < 2V
2 microsecond min. pulse width is required for either mode
Sensor Status Indicator
Yellow (flashing): Power ON, sensor initializing and executing self-
diagnostics
Yellow (solid): Power ON, sensor not in RUN mode
Green: Power ON, sensor in RUN mode, READY to process triggers
Red: Power is ON, hardware fault has been detected
(Continued on page 18)

REFERENCE

17