Table of Contents
Advertisement
4. Tighten the mounting screws to secure the device (or the device and the bracket) in the aligned position.
Figure 5. Mounting Holes
Mounting Surface Thickness
≤ 2 mm
2 mm to 4 mm
4 mm to 6 mm
2.3 Wiring
To maintain the ratings listed in the Specifications, use cables with shields.
Tighten the cables finger tight only.
Figure 6. Channel 1 as PNP Output, Channel 2 as Trigger
Input
bn (1)
bu (3)
bk (4)
Load
wh (2)
Remote
Input
Table 1: Power and I/O Pinouts
Pin
Wire Color
1
Brown
2
White
3
Blue
4
Black
2.4 Install the Software
Use the following instructions to install the Banner 3D Configuration software on your computer.
Important: Administrative rights may be required to install the Banner 3D Configuration software.
1. Download the latest version of the software from www.bannerengineering.com.
2. Navigate to and open the downloaded file.
3. Run the downloaded installer.
4. Check the agreement for license terms and conditions.
Figure 7. Channel 1 as NPN Output, Channel 2 as Trigger
bn (1)
12–30 V DC
bu (3)
bk (4)
wh (2)
Description
12 V DC to 30 V DC
Trigger Input or Output (selectable PNP, NPN, or push-pull)
Common
Output (selectable PNP, NPN, or push-pull)
www.bannerengineering.com - Tel: + 1 888 373 6767
ZMX Series 3D Time of Flight Sensor
Note: Do not remove the housing screws.
Note: Provide adequate dissipation of heat.
A good heat conductor, such as aluminum,
may be required.
Length of Mounting Screws
4 mm
6 mm
8 mm
Input
12–30 V DC
Load
Remote
Input
Figure 8. M8 Male Connector
2
4
1
3
7
Advertisement
Table of Contents
