Forced Cold-Start Settings - Agilent Technologies 1200 Series Reference Manual

7 Introduction to the Quaternary Pump
One start bit and one stop bit are always used (not selectable).
Per default, the module will turn into 19200 baud, 8 data bit with no parity.
Table 41

Forced Cold-Start Settings

Switches 1 and 2 do not force storage of this set of parameters in non-volatile
memory. Returning the switches 1 and 2 to other positions (other than being
both up) will allow for normal operation.
A forced cold start erases all methods and data stored in non-volatile memory.
C A U T I O N
Exceptions are diagnose and repair logbooks will not be erased.
If you use the following switch settings and power the instrument up again, a
forced cold start has been completed.
Table 42
To return to normal operation, set switches back to your GPIB or RS 232C
configuration settings.
232
Parity Settings
Switches Parity
7 8
0 0 No Parity
0 1 Odd Parity
1 0 Even Parity
Forced Cold Start Settings
Mode Select 1
TEST/BOOT 1
2 3 4
1 0 0
5 6 7
0 0 0
1200 Series QP Reference Manual
8
1