Agilent 1200 Series Interfaces - Agilent Technologies 1200 Series Reference Manual

7 Introduction to the Quaternary Pump

Agilent 1200 Series Interfaces

The Agilent 1200 Series modules provide the following interfaces:
Table 32

Agilent 1200 Series Interfaces

Interface Type Pumps
CAN Yes
GPIB Yes
RS-232C Yes
APG Remote Yes
Analog Yes
Interface board Yes
* The vacuum degasser will have a special connector for specific use. For details, see the degasser manual.
• The CAN connectors serve as the interface between the Agilent 1200 Series
• the GPIB connector serves as the interface between an Agilent 1200 Series
• RS-232C provides an interface to a computer,
• the APG remote connector serves as the interface between the Agilent 1200
• the analog output connector(s) provide an analog signal output,
• the interface board slot (not common to all modules) provides specific
Never use cables other than the ones supplied by Agilent Technologies to ensure
WA R N I N G
proper functionality and compliance with safety or EMC regulations, see
Overview"
224
Autosampler
Yes
Yes
Yes
Yes
No
Yes
modules themselves,
module and the Agilent ChemStation,
Series and other Agilent (APG remote compatible) products,
interfacing needs (external contacts, BCD, LAN and so on).
on page 184.
DA Detector VW Detector
MW Detector RI Detector
FL Detector
Yes Yes
Yes Yes
Yes Yes
Yes Yes
2 × 1 ×
Yes Yes
Thermostatted Vacuum
Column Degasser
Compartment
Yes No
Yes No
Yes No
Yes Yes
*
No Yes
No No
"Cable
1200 Series QP Reference Manual