Agilent Technologies 1200 Series Reference Manual page 23

6 Connect all capillaries, solvent tubes and waste tubing (see
7 Press power switch to turn on the quaternary pump.
The power switch stays pressed in and a green indicator lamp in the power switch is on
N O T E
when the quaternary pump is turned on. When the line power switch stands out and the
green light is off, the quaternary pump is turned off.
8 Purge the quarternary pump (see
To disconnect the quaternary pump from line, unplug the power cord. The power
WA R N I N G
supply still uses some power, even if the power switch on the front panel is turned
off.
The pump was shipped with default configuration settings. To change these settings,
N O T E
"Setting the 8-bit Configuration Switch"
1200 Series QP Reference Manual
Connections of the Quaternary Pump"
page 27).
on page 24).
"Priming and Purging the System"
on page 229
Installing the Pump
"Flow
on
1
23