Gpib Default Addresses - Agilent Technologies 1200 Series Reference Manual

7 Introduction to the Quaternary Pump
Switches 1 and 2 define which set of parameters (for example, for GPIB,
RS-232C, and so on) will be changed. Once the change has been completed, the
instrument must be powered up again in order to store the values in the
non-volatile memory.
In the non-volatile memory the parameters are kept, regardless of whether you
turn the instrument off and on again. They will be kept until the same set of
parameters is subsequently changed and power is reset. All other previously
stored configuration settings will still remain in the non-volatile memory.
In this way you can store more than one set of parameters using the same 8-bit
configuration switch twice,, for example, for both GPIB and RS-232C.

GPIB Default Addresses

If you just want to change the GPIB address and need a detailed procedure,
refer to the Installing Your ChemStation System handbook. Default GPIB
address is set to the following addresses::
Table 37
Module
Pump
FLD
VWD
Agilent 8453A
DAD/MWD
Column compartment
Autosampler
RID
where 0 means that the switch is down and 1 means that the switch is up.
230
Default Addresses for Agilent 1200 Series Modules
Address
22
23
24
25
26
27
28
29
Binary Address
0 0 0 1 0 1 1 0
0 0 0 1 0 1 1 1
0 0 0 1 1 0 0 0
0 0 0 1 1 1 0 1
0 0 0 1 1 0 1 0
0 0 0 1 1 0 1 1
0 0 0 1 1 1 0 0
0 0 0 1 1 1 0 1
1200 Series QP Reference Manual