Lan Communication Card - Agilent Technologies 1200 Series Reference Manual

LAN Communication Card

One board is required per Agilent 1200 Series stack. It is recommended to add the LAN
N O T E
board to the detector with the highest data rate (DAD/MWD/FLD/VWD)..
The LAN board can only be used together with:
N O T E
A DAD/MWD/VWD/Pump/ALS with main board version G13XX-66520 and greater. An
FLD/RID with main board version G13XX-66500 and greater.
a DOS-ChemStation software revision A.06.01 or above.
The following boards can be used with the Agilent 1200 Series modules.
Table 31 LAN Boards
Type Vendor
G1369A Agilent Technologies
G1369-60001
J4106A (*) Hewlett Packard
J4105A (*) Hewlett Packard
J4100A (*) Hewlett Packard
These cards (*) may no longer be orderable. Minimum firmware of these Hewlett Packard
N O T E
JetDirect cards is A.05.05.
Recommended Cables
1200 Series QP Reference Manual
Supported networks
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX)
recommended for re-ordering
Ethernet/802.3, RJ-45 (10Base-T(
Token Ring/802.5, DB9, RJ-45 (10Base-T)
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC (10Base2)
Cross-over network cable (shielded, 3 m long),
(for point to point connection)
Twisted pair network cable (shielded, 7 m long)
(for hub connections)
Introduction to the Quaternary Pump
5023-0203
5023-0202
7
223