Operation; Definitions; Hw 100 System - Pace HW 100 HeatWise Operation And Maintenance Manual

Operation

Definitions

Please read and become familiar with the definitions of each of the following terms that are used
repeatedly in the following operational procedures.
Auto-Off: Safety feature that turns power off (10-90 minutes, settable in 10 minute increments)
after the system has entered Temperature Setback.
Normal Operation:
Temperature is displayed.
Password: The Password feature of the TW 100 system will prevent unauthorized alteration of
stored system temperature parameters and feature settings. If a Password has been installed,
the LED Display will display an instruction to enter the Password (a 3 digit number selected using
the scroll up/down keys on the system front panel) when a setting change is attempted.
Programming Menu: The interface used to program the system features parameters (e.g.,
temperature limits, password, setback time).
Set Tip Temperature:
memory.
Temperature Adjust Mode:
adjusted.
Temperature Setback: System feature that will independently set back the Set Tip Temperature
to 177°C (350°F) after a user selected or preset period of handpiece inactivity.
HW 100 Heat Wise System
The HW 100 requires the use of a Power Module. The Power Module
selects the desired heat level for operation. The HW 100 comes
standard with three Power Modules, Heat Levels 6.5, 7, & 7.5.
Additional Power Modules are available in heat levels of 5, 5.5, 6,
8, and 8.5. Please refer to the Accessory Section for Power Module
part numbers. A heat level of 5 corresponds to a nominal temperature
of 500 °F; a heat level of 6.5 corresponds to a temperature of 650 °F,
etc. Actual temperatures may vary slightly due to tip geometry.
Verify the following:
1. Handpiece connection to the power source.
2. Power cord connection between an appropriate AC supply
receptacle and the power source.
If the power is turned on while a Power Module is not installed, or if the Power Module is removed
during operation, the system will turn itself off and the LED indicator light on the front panel will turn
red.
To operate the unit, please make sure the set-up procedure has been followed. Then follow the
procedure below.
1. Install the desired Tip Cartridge.
2. Install the desired Power Module into the Power Port on the front of the unit.
3. The LED indicator will turn amber while the tip is heating to the desired performance level.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Normal operating mode of the system in which the Operating Tip
The operator selected idle tip temperature entered into the system
Mode of operation where the Set Tip Temperature may be
LED
Indicator
Power
Module
Page 7 of 17