Quick Start - Basic Operation; Introduction; Quick Start Procedure - Pace ST 85 Operation & Maintenance Manual

Introduction

The ST 85 system is very easy to operate. As received from the factory, the system
can be quickly set up for use in standard desoldering/soldering operations. Simply
perform the following Quick Start Procedure to begin system operation.

Quick Start Procedure

1. Ensure that the Set-Up procedure has been performed; including the
Heater Burn In procedure. Check for the following:
a) Handpiece connections (connector plug and air hose) to the power
source.
b) Proper tip installed in handpiece.
c) Power cord connection between house AC
supply receptacle and the power source.
d) House air supply connection to power supply.
2. Turn the Power Switch "On" ("I").
3. Press the Scroll Up ( ) Key to enter the Temperature Adjust Mode.
4. Press the Scroll Up ( ) Key to increase the desired Tip Temperature.
Press the Scroll Down ( ) Key to decrease the desired Tip Temperature.
5. Press the Program Key (
normal operation.
6. Observe the Digital Readout as the temperature stabilizes at the desired
Set Tip Temperature.
7. If you have a Sodr-X-Tractor or other PACE air handpiece connected to
your system, press and hold the Vacuum Switch to check for proper
operation. You will hear a clicking noise as the air is turned on in the
system. An audible sound of air movement will be present. Release the
Vacuum Switch.
Read the "Operation" and "Set-Up Mode" sections of this manual to utilize the full
capabilities of the system. This is especially important when using large soldering
tips or other SensaTemp handpieces.
20

Quick Start - Basic Operation

). The system will now return to
NOTE