Roller Wheels; Adjustment Procedure - Landoll BRILLION SL Series Operator's Manual

Turfmaker seeder

Table of Contents

MAINTENANCE & ADJUSTMENT

Roller Wheels

Occasionally it is necessary to loosen clamp bands and

tighten roller wheel assemblies. As nearly as possible,

peaks on rear wheels should line up with valleys on the

front wheels. This requires adjusting both end clamps on

the rear axle drum.

Adjust the front roller wheels first. Loosen clamp bands

and slide wheels snug against each other, centering the

entire assembly under the deflector shields. Locate the

bolt in the clamp band over the weld on the pipe. Slide

the clamp band against the end wheel and tighten the

clamp band bolt. See Figure 4-6.

To adjust the rear roller wheels follow the front wheel

procedure. Start aligning the peaks of the rear wheels

with the valley of the front wheels at the center of the rear

roller. This will provide the best alignment of worn

wheels.

Figure 4-6: Roller Wheel Adjustment

4-6

1P342

Table of Contents

Show Quick Links

Table of Contents