Coil Tine Track Remover (Optional) - Landoll BRILLION SL Series Operator's Manual

Coil Tine Track Remover
(Optional)
NOTE
Cannot be used with the Scraper Kit
1. Assemble the coil tines and arm weldments to the
1-1/2" diameter x 29" bar. The arm weldments may
be placed anywhere along the bar, but it is suggested
that they be mounted in the second hole from the
right end, and the third hole from the left end. (Left
end and right end designations are those related to
the operator when sitting in the operating position).
2. Mount 6 of the coil tines to the bar with 3/8" x 2- 1/2"
capscrews, flat washers, lockwashers, and nuts.
3. Mount the other two coil tines to the bar with the 3/8"
x 3" capscrews, lockwashers, and nuts which also
attach the arm weldments to the bar.
4. Clamp the brackets loosely to the seeder frame, with
u-bolts, lockwashers, and nuts.
5. Attach the adjusting angles to frame brackets with
lockscrews. Secure the adjusting angle from
swinging with a 1/2" clevis pin and hair pin cotter.
6. Fasten the bar and tine assemblies to the adjusting
angles with 1/2" x 1-3/4" capscrews and locknuts.
Tighten the locknuts to allow the free side to side
swing.
7. Center the entire wheel track leveler behind the
tractor tires. Tighten the u-bolts against the seeder
frame. See Figure 2-25.
8. Attach the chains' end links to the adjusting angles
with 3/8" x 1-1/4" capscrews, flat washers,
lockwashers and nuts. There is one chain for the left
side and one chain for the right side.
The vertical position can be changed by removing the
clevis pins and lock screws and moving the adjusting
angles up or down.
To inactivate the tines, remove the 1/2" clevis pins and
loosen the lock screws. Then swing the bar and tine
assemblies upward and sideways. To hold in place, wrap
the chain under the bar and place the chain into the slot
in the adjusting angle. Re-tighten the lock screws.
Figure 2-25: Coil Tine Setup
ASSEMBLY INSTRUCTIONS
2-23