Table of Contents
Advertisement
Calibration procedure
12.2.4.2
Clear Calib.
12.2.5
Inputs/outputs
'Auxiliary capacity'
12.2.5.1
4.
Lead the suction hose into a measuring cylinder containing the feed
chemical – make sure that the discharge hose is installed perma‐
nently (operating pressure, ...!).
5.
Prime the feed chemical (press
empty.
1.
Record the level in the measuring cylinder.
2.
'Menu / Information è Settings è Calibrate' '' menu and
Select the
[Clickwheel] .
press the
ð The
'Start calibration' (PUSH) menu item appears.
3.
To start calibration, press the
'Calibrate ...' menu item appears, the pump starts to pump
ð The
and indicates the number of revolutions.
4.
After a reasonable number of revolutions (a minimum of 200), use
[Clickwheel] to stop the pump.
the
ð The
'Calibrate ended' menu item appears. It asks you to enter
the calibration volume.
5.
Determine the required metering volume (difference between initial
volume - remaining volume in the measuring cylinder).
[Clickwheel] to enter this volume in the 'Calibrate ended'
6.
Use the
menu item and close.
ð The pump switches to the
pump is calibrated.
[Clickwheel] .
7.
Press the
ð The pump returns to the
Use this menu to reset the calibration data to factory settings.
'Menu / Information è Settings è Inputs/outputs è ...'
'Inputs/outputs' menu is generally split into the following sub-menus:
The
'Auxiliary capacity'
1 -
'Relay1' (optional)
2 -
3 -
'Relay2' (optional)
'mA-Output' (optional)
4 -
'Pause input' (optional)
7 -
'Level monitoring'
6 -
'Hose rupture error' (optional)
7 -
'Menu / Information è Settings è Inputs/outputs
Auxiliary capacity è ...'
è
'Auxiliary capacity' function enables the pump to be
The programmable
switched over to an additional capacity that can be fixed in the
capacity' menu.
Set up /
[Priming] ) if the suction hose is
[Clickwheel] .
'Calibration result' menu item - the
'Menu / Information è Settings' menu.
'Menu'
'Auxiliary
53
Advertisement
Table of Contents
