Table of Contents
Advertisement
Regulatory information
FCC (United States)
These RF modules comply with Part 15 of the FCC rules and regulations. Compliance with the labeling
requirements, FCC notices and antenna usage guidelines is required.
In order to operate under Digi's FCC Certification, integrators must comply with the following
regulations:
1. The integrator must ensure that the text provided with this device (in the labeling
requirements section that follows) is placed on the outside of the final product and within the
final product operation manual.
2. The device may only be used with antennas that have been tested and approved for use with
this device; refer to
OEM labeling requirements
WARNING! The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the final product
enclosure that displays the text shown in the figure below.
The following text is the required FCC label for OEM products containing the XBee-PRO SX RF Module:
Contains FCC ID: MCQ-XBPSX
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any
interference received, including interference that may cause undesired operation.
The following text is the required FCC label for OEM products containing the XBee SX RF Module:
Contains FCC ID: MCQ-XBSX
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any
interference received, including interference that may cause undesired operation.
FCC notices
IMPORTANT: These RF modules have been certified by the FCC for use with other products without
any further certification (as per FCC section 2.1091). Modifications not expressly approved by Digi
could void the user's authority to operate the equipment.
IMPORTANT: Integrators must test final product to comply with unintentional radiators (FCC sections
15.107 & 15.109) before declaring compliance of their final product to Part 15 of the FCC rules.
IMPORTANT: These RF modules have been certified for remote and base radio applications. If the
module will be used for portable applications, the device must undergo SAR testing.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Re-orient or relocate the receiving antenna,
XBee®/XBee-PRO XTend Compatible (XTC) DigiMesh RF Module User Guide
FCC antenna
certifications.
FCC (United States)
106
Advertisement
Table of Contents
