AT commands
RE (Restore Defaults)
Restore device parameters to factory defaults.
Parameter range
N/A
Default
N/A
WR (Write)
Writes parameter values to non-volatile memory so that parameter modifications persist through
subsequent resets.
Note
Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A
R1 (Restored Compiled)
Restore device parameters to the compiled defaults.
Parameter range
N/A
Default
N/A
XBee®/XBee-PRO XTend Compatible (XTC) DigiMesh RF Module User Guide
Special commands
57