Table of Contents
Advertisement
Agency certifications
FCC (United States) certification
The XTend RF Module complies with Part 15 of the FCC rules and regulations. Compliance with the labeling
requirements, FCC notices and antenna usage guidelines is required.
In order to operate under Digi's FCC Certification, integrators must comply with the following regulations:
1. The integrator must ensure that the text provided with this device [Figure 1] is placed on the outside of the final
product and within the final product operation manual.
2. The XTend RF Module may only be used with antennas that have been tested and approved for use with this
module [refer to
Integrator labeling requirements
WARNING!
Figure 1: Required FCC Label for OEM products containing the XTend RF Module
Contains FCC ID: OUR-9XTEND OUR-9XTEND
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(i.) this device may not cause harmful interference and (ii.) this device must accept any interference received,
including interference that may cause undesired operation.
FCC notices
IMPORTANT: The XTend RF Module has been certified by the FCC for use with other products without any further
certification (as per FCC section 2.1091). Modifications not expressly approved by Digi could void the user's authority
to operate the equipment.
IMPORTANT: Integrators must test final product to comply with unintentional radiators (FCC sections 15.107 &
15.109) before declaring compliance of their final product to Part 15 of the FCC rules.
XTend RF Module User Guide
FCC-approved antennas
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. This
includes a clearly visible label on the outside of the final product enclosure that displays the text shown
in the figure below.
on page 76].
75
Advertisement
Table of Contents
