Rr (Unicast Mac Retries); Network Commands; Bh (Broadcast Hops) - Digi XBee XTC User Manual

AT commands
Power supply
3.3 to 3.6 V
3.0 V
2.6 V
Parameter range
0 - 4
These parameters equate to the following settings for the XTC DigiMesh module:
Setting
0
1
2
3
4
Default
4

RR (Unicast Mac Retries)

Set or read the maximum number of MAC level packet delivery attempts for unicasts. If RR is non-
zero, the sent unicast packets request an acknowledgment from the recipient. Unicast packets can
be retransmitted up to RR times if the transmitting device does not receive a successful
acknowledgment.
Parameter range
0 - 0xF
Default
0xA (10 retries)

Network commands

The following commands are network commands.

BH (Broadcast Hops)

The maximum transmission hops for broadcast data transmissions.
If you set BH greater than NH, the device uses the value of NH.
Parameter range
0 - 0x20
XBee®/XBee-PRO XTend Compatible (XTC) DigiMesh RF Module User Guide
Output power @ PL = 3
30 dBm typical
29 dBm typical
27 dBm typical
XTC power level
0 dBm
10 dBm
13 dBm
13 dBm
13 dBm
Network commands
XTC PRO Power level
21.5 dBm
27 dBm
30 dBm
50