Table of Contents
Advertisement
United States (FCC)
The Digi Connect EM and Wi-EM modules comply with Part 15 of the FCC rules and regulations.
Compliance with the labeling requirements, FCC notices and antenna usage guidelines is required.
To fulfill FCC certification requirements, the OEM must comply with the following regulations:
The system integrator must ensure that the text on the external label provided with this
n
device is placed on the outside of the final product.
The Digi Connect EM and Wi-EM modules may only be used with antennas that have been
n
tested and approved for use with these modules; refer to
America.
OEM labeling requirements
WARNING! As an Original Equipment Manufacturer (OEM) you must ensure that FCC
labeling requirements are met. You must include a clearly visible label on the outside of
the final product enclosure that displays the following content:
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
If the FCC ID / IC ID is not visible when installed inside another device, then the outside of the device
into which the module is installed must also display a label referring to the enclosed module FCC ID /
IC ID. This exterior label can use wording such as the following: "Contains Transmitter Module FCC ID:
MCQ-50M879" / IC: 1846A-50M879."
FCC notices
IMPORTANT: This device has been certified by the FCC for use with other products without any further
certification (as per FCC section 2.1091). Modifications not expressly approved by Digi could void the
user's authority to operate the equipment.
IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107
and 15.109) before declaring compliance of their final product to Part 15 of the FCC rules.
IMPORTANT: The module has been certified for remote and base radio applications. If the module will
be used for portable applications, please take note of the following instructions:
For embedded modules where the antenna gain is less than 13.8 dBi, no additional SAR testing
n
is required. The 20 cm separation distance is not required for antenna gain less than 13.8 dBi.
For embedded modules where the antenna gain is greater than 13.8 dBi, the device must
n
undergo SAR testing.
Digi Connect EM and Digi Connect Wi-EM Hardware Reference
Antenna specifications for North
59
Advertisement
Table of Contents
